Jump to content

how do u remove the cable cover on the right side of UM3

ultradryan

By ultradryan
in UltiMaker 3D printers

 Share

Recommended Posts

ultradryan

ultradryan 9

Posted
Posted · how do u remove the cable cover on the right side of UM3

ok, so i sort of being able to pull the cable cover on the left side.
but the one on the right side i.... just cant seem to find the right way to pull it off...
Any tricks on that? I need to replace the printcore cable....... and i need to pull that cover off to do so....

    • Link to post
    Share on other sites
    IRobertI

    IRobertI 520

    Posted
    Posted · how do u remove the cable cover on the right side of UM3

    I have yet to find an easy way to remove them. Brute force seems to be the way to go 🙂

     

    To get them back in place is also a pain in the arse. But I find that if you snip off the little tab at the bottom of the cover it makes it a lot easier since the cover is "over constrained" , to use CAD terms, with the bottom tab.

    • Link to post
    Share on other sites

    Create an account or sign in to comment

    You need to be a member in order to leave a comment

    Create an account

    Sign up for a new account in our community. It's easy!

    Register a new account

    Sign in

    Already have an account? Sign in here.

    Sign In Now
     Share
    Go to topic listing

    • Our picks

      • UltiMaker Cura 5.7 stable released

        UltiMaker Cura 5.7 stable released

        ArunC posted a topic in UltiMaker Cura,

        Cura 5.7 is here and it brings a handy new workflow improvement when using Thingiverse and Cura together, as well as additional capabilities for Method series printers, and a powerful way of sharing print settings using new printer-agnostic project files! Read on to find out about all of these improvements and more. 
         
          • Like
        • 18 replies
        MariMakes

        Picked By

        MariMakes,

      • Release Notes: S-Line Firmware 8.3.0 (Latest)

        Dustin posted a topic in Firmware,

        S-Line Firmware 8.3.0 was released Nov. 20th on the "Latest" firmware branch.
        (Sorry, was out of office when this released)

        This update is for...
        All UltiMaker S series  
        New features
         
        Temperature status. During print preparation, the temperatures of the print cores and build plate will be shown on the display. This gives a better indication of the progress and remaining wait time. Save log files in paused state. It is now possible to save the printer's log files to USB if the currently active print job is paused. Previously, the Dump logs to USB option was only enabled if the printer was in idle state. Confirm print removal via Digital Factory. If the printer is connected to the Digital Factory, it is now possible to confirm the removal of a previous print job via the Digital Factory interface. This is useful in situations where the build plate is clear, but the operator forgot to select Confirm removal on the printer’s display. Visit this page for more information about this feature.
          • Like
        • 0 replies
        MariMakes

        Picked By

        MariMakes,
      View All
    ×
    ×
    • Create New...