Cura stuttering on curves

[stenkluts 2]

Hi Guys, 

 

I do still have this problem, with slight curves  (but also bigger ones) cura stutters, stops at every gcode point and sometimes even moves a bit back and forward again. 

 

As i am using a post processor to change the code from XY > XYZ movements (FFF 45 degree printer) i cannot use arc moves

 

Hoping someone still cares about this problem. Had it on cura 5.2.1 and on 5.6.0

Other slicers do not have the same problem but for instance, prusaslicer doesnt go bigger that 1,2x1,2m so thats a no go for me.

 

Kind regards!

[Slashee_the_Cow 273]

6 hours ago, stenkluts said:

As i am using a post processor to change the code from XY > XYZ movements (FFF 45 degree printer) i cannot use arc moves

That sort of printer isn't what Cura is designed for, but the fault probably lies with the post processor turning simple moves into a lot of commands.