Pause at Height, Cura 4.2.1 = problems with nozzle position

[cbirer 0]

Hi Ultimaker/Cura people, 

 

I have problems with my print since I have updated Cura. Before, I was using print at height with 7mm, and it worked fine. Now, it is not working anymore if I am using pause at height with mm, but it is only working with pause at height with layer. This is weird. So I have switch to the layer system, and ask to pause at layer 48, and it is working in the sense that it is making a pause. But, when you start the print again, it can print anything because the nozzle is too high, too far from the print. 

 

Do you have a solution please?

 

Thanks

[Mari 38]

I seem to have the same problem, "pause at height" worked for me with previous versions, but with the latest 4.2.1 version the nozzle is too high when print resumes...

 

[Mari 38]

It's definitely a "bug" in V4.2.1. Have installed v4.1.0 and created the same gcode-file. After pause printing is resumed on the right height!

[Smithy 1,146]

It is fixed in 4.3. beta and working again.

[Mari 38]

Thnx... will wait for the official release of V4.3.x

[cbirer 0]

Hi all, 

 

Thanks Mari and Smithy, I was really trying to make it worked since few weeks, before to think about to leave a message here. I feel a bit a less silly... 

I will do like you, installed the 4.1.0 and wait the official release of v4.3.x

 

[Mari 38]

No need to feel silly...😉  I was searching the internet and found by accident your post on this forum. I messed up a few prints and was sure that my printer was ok...  the only thing that had changed was the CURA-version.

 

Now it is confirmed we know for sure... workarround: installing V4.1.0 or v4.3 beta...