UltiMaker uses functional, analytical and tracking cookies. Tracking cookies enhance your experience on our website and may also collect your personal data outside of Ultimaker websites. If you agree with the use of tracking cookies, click “I agree, continue browsing”. You can withdraw your consent at any time. If you do not consent with the use of tracking cookies, click “Refuse”. You can find more information about cookies on our Privacy and Cookie Policy page.
Cura 5.7 is here and it brings a handy new workflow improvement when using Thingiverse and Cura together, as well as additional capabilities for Method series printers, and a powerful way of sharing print settings using new printer-agnostic project files! Read on to find out about all of these improvements and more.
S-Line Firmware 8.3.0 was released Nov. 20th on the "Latest" firmware branch.
(Sorry, was out of office when this released)
This update is for...
All UltiMaker S series
New features
Temperature status. During print preparation, the temperatures of the print cores and build plate will be shown on the display. This gives a better indication of the progress and remaining wait time. Save log files in paused state. It is now possible to save the printer's log files to USB if the currently active print job is paused. Previously, the Dump logs to USB option was only enabled if the printer was in idle state. Confirm print removal via Digital Factory. If the printer is connected to the Digital Factory, it is now possible to confirm the removal of a previous print job via the Digital Factory interface. This is useful in situations where the build plate is clear, but the operator forgot to select Confirm removal on the printer’s display. Visit this page for more information about this feature.
Recommended Posts
Digibike 107
Sicher, dass dein Abstand Bett Nozzle noch stimmt/gleichmäßig ist?
Wenn ich den inneren "Kreis" der ersten Schicht so ansehe, hat sich der "Faden"
schon überlegt, mitzuwandern. Daher diese Eckige Außenkontur - ist ja mehr 8-eck
wie rund. Da würde ich vermuten, dass entweder der Abstand etwas zu groß
gewählt ist oder das Bett nicht sauber gelevelt ist und sich dadurch in Bereichen
mehr Abstand als in anderen ergibt (Bett hängt nach einer Seite). Links sieht es
jedenfalls so aus, als ob da schon der Faden sich gelöst hätte und quer rüber
gezogen hätte. Da das Objekt auf den Kopf steht, wohl die rechte Betthälfte.
Ich vermute mal, rechts hängt es etwas und ist insgesamt grenzwertig groß, der
Abstand.
Gruß, Digibike
Link to post
Share on other sites