UltiMaker uses functional, analytical and tracking cookies. Tracking cookies enhance your experience on our website and may also collect your personal data outside of Ultimaker websites. If you agree with the use of tracking cookies, click “I agree, continue browsing”. You can withdraw your consent at any time. If you do not consent with the use of tracking cookies, click “Refuse”. You can find more information about cookies on our Privacy and Cookie Policy page.
Cura starting a circle in mid air (Not able to use support)
Posted
· Cura starting a circle in mid air (Not able to use support)
in Cura under Shell there is a setting called 'outer before inner walls'
This should print the outside wall first and then inner walls.
I dont know what material you are printing with, but you should look at the temperature from the water and the smoke to make sure it does not melt or deform the filament. That would not be very healty to inhale 😉 .
We are happy to announce the next evolution in the UltiMaker 3D printer lineup: the UltiMaker Factor 4 industrial-grade 3D printer, designed to take manufacturing to new levels of efficiency and reliability. Factor 4 is an end-to-end 3D printing solution for light industrial applications
Cura 5.7 is here and it brings a handy new workflow improvement when using Thingiverse and Cura together, as well as additional capabilities for Method series printers, and a powerful way of sharing print settings using new printer-agnostic project files! Read on to find out about all of these improvements and more.
Recommended Posts
NickB 2
in Cura under Shell there is a setting called 'outer before inner walls'
This should print the outside wall first and then inner walls.
I dont know what material you are printing with, but you should look at the temperature from the water and the smoke to make sure it does not melt or deform the filament. That would not be very healty to inhale 😉 .
Hope this solves your problem.
Link to post
Share on other sites