Jump to content

Outer wall indented lines


japs

Recommended Posts

Posted · Outer wall indented lines

Hello,

I'm currently printing on a (sigh) Geeetech A20 using (yey) Cura software.

I've been experiencing these lines in the outer walls of my prints for some days now, and i've tried to tweak almost every parameter to non avail.

It looks like some layers are under extruding while others pop out;

doesn't seem to happen in a cyclical manner, just an indented line every now and then.

Retraction and coasting are activated since i'm printing 2 parts at the same time,

although the same thing happens in a single piece print (with these switched off)

 

If anyone has had this issue before can please give me a hint on what to look for?

 

checked bowen extruder calibration

keeping the printer safe from environement changes and on firm surface

Using Geeetech black PLA

bed temp. 55°

nozzle 190° (best results so far)

print speed 80 mms

wall speed 40 mms

layer height 0.15

in. layer heigh 0.15

retraction 3.5 mm

ret. speed 65 mms

coasting volume 0.08

min. ammount 0.8

coast speed 100%

compensate wall overlaps (inner + outer) true

all of above been tested in a ±5 range (or in small values for millimeters)

 

Thankyou in advance

 

 

20191121_153205.jpg

20191121_153145.jpg

CFFFP_divano 2.gcode

  • Link to post
    Share on other sites

    Create an account or sign in to comment

    You need to be a member in order to leave a comment

    Create an account

    Sign up for a new account in our community. It's easy!

    Register a new account

    Sign in

    Already have an account? Sign in here.

    Sign In Now
    • Our picks

      • Introducing the UltiMaker Factor 4
        We are happy to announce the next evolution in the UltiMaker 3D printer lineup: the UltiMaker Factor 4 industrial-grade 3D printer, designed to take manufacturing to new levels of efficiency and reliability. Factor 4 is an end-to-end 3D printing solution for light industrial applications
          • Thanks
          • Like
        • 3 replies
      • UltiMaker Cura 5.7 stable released
        Cura 5.7 is here and it brings a handy new workflow improvement when using Thingiverse and Cura together, as well as additional capabilities for Method series printers, and a powerful way of sharing print settings using new printer-agnostic project files! Read on to find out about all of these improvements and more. 
         
          • Like
        • 26 replies
    ×
    ×
    • Create New...