-
Our picks
-
Introducing the UltiMaker Factor 4
ArunC posted a topic in UltiMaker 3D printers,
We are happy to announce the next evolution in the UltiMaker 3D printer lineup: the UltiMaker Factor 4 industrial-grade 3D printer, designed to take manufacturing to new levels of efficiency and reliability. Factor 4 is an end-to-end 3D printing solution for light industrial applications-
-
- 3 replies
.thumb.jpeg.0b7a05eafc09add17b8338efde5852e9.jpeg)
Picked By
MariMakes, -
-
UltiMaker Cura 5.7 stable released
ArunC posted a topic in UltiMaker Cura,
Cura 5.7 is here and it brings a handy new workflow improvement when using Thingiverse and Cura together, as well as additional capabilities for Method series printers, and a powerful way of sharing print settings using new printer-agnostic project files! Read on to find out about all of these improvements and more.
-
-
- 26 replies
Picked By
MariMakes, -
-
.thumb.jpeg.0b7a05eafc09add17b8338efde5852e9.jpeg)
Recommended Posts
Smithy 1,144
Hi and welcome!
I am not sure if I understood your question, recovery and backup are different things, but I will try to answer it.
There is no option to backup your firmware, and in my opinion it is not really needed, there are only a few settings so you can quickly setup the printer again without restoring a backup.
A recovery from what? Is your printer bricked and not working at all? Then there exists a recovery option but depends on your printer model.
Or do you just want to reset everything, then use the factory reset from the menu.
Link to post
Share on other sites
gr5 2,189
Which UM printer do you have? Instructions for recovery vary depending.
Link to post
Share on other sites