brim and support

[aag 6]

I have changed  some settings, and now Cura is making a brim with Extruder 2 (PVA) surrounded by a second brim with Extruder 1. However I do not see how I can revert to normal, which would be an Extruder-1-only brim. Can somebody enlighten me? Thanks in advance

 

 

[Enigma_M4 121]

Hi aag,

 

If you select the main tab for extruder 2, what's the value for build plate adhesion extruder there? If it's extruder 2, that might be the culprit; change to extruder 1.

 

Regards

[yuvalml 0]

Hi, im having the same problem

did you fixed it?

[gr5 2,235]

I believe this change has a good reason for it.  I also find it surprising and annoying but I ignore it and the printer is able to print the part just fine.  So maybe there is a good reason for it?