SOLVED Cura 4.4.0 preview is inverted

[sanslos 0]

The preview in Cura 4.4.0 is inverted, showing the complete structure at layer 1, and moving toward a greyed out image on the last layer.  Not sure when this started, never saw it in previous versions.  I played with colors on my material, perhaps that contributed?  The model prints correctly.  This is scaled up (by 7,000%) and rotated 90% from the original.

[gr5 2,265]

This is on purpose.  If you look more carefully - on the right side there is a blue dot both at the top and bottom of the vertical slider.  If you want the old behavior then only move the top blue dot.  You moved the new dot - the bottom one - that wasn't in the older version of cura.

[sanslos 0]

Well, now it seems obvious 🙂  Thanks.