Cura Parameter for Min / Max Print Coordinates?

[lars86 42]

Hey guys, I was hoping that Cura could pass parameters for the minimum and maximum x and y values used in a given print.

 

My thought is that you could push these values forward into mesh leveling bounds and quickly probe the area of bed being used without waste.

[gr5 2,234]

plus 100 for this one.  I feel like Ultimaker could save millions of man hours on this one (assuming there are a million S5 and S3 printers out there, he he).  It would save their own employees significant time as well.

[ahoeben 1,990]

More information here:

https://github.com/Ultimaker/Cura/issues/7270

 

Cross-posting is not always a good idea; it splinters the discussion.

[ahoeben 1,990]

On 3/11/2020 at 9:33 PM, gr5 said:

I feel like Ultimaker could save millions of man hours on this one...

 

AFAIK, this is already implemented in the firmware for the S5 (and S3?).

[lars86 42]

On 3/13/2020 at 4:47 AM, ahoeben said:

More information here:

https://github.com/Ultimaker/Cura/issues/7270

 

Cross-posting is not always a good idea; it splinters the discussion.

 

 

The overlap between devs on GitHub and users on the UM forum is probably pretty small.

 

On this forum, it's possible some users have already found ways to do this.

 

On GitHub, the devs have the ability to add features or report details that might be otherwise unpublished.

[ahoeben 1,990]

So, where do you want my input? Here or on github?

[lars86 42]

6 hours ago, ahoeben said:

So, where do you want my input? Here or on github?

 

 

Completely up to you.