Jump to content

Ejecting filament at the end of the print.

Recommended Posts

Posted · Ejecting filament at the end of the print.


I am currently printing out face shields and I've come across a problem that I can't seem to resolve I wonder if anybody can point me in the right direction. At the end of each print the filament is fully rejected from the hot end now in most circumstances this would be a good thing however because I'm continually printing having to feed in the filament after every print is becoming a bit tedious after I've done it 90 times. So does anyone know using Cura 4.5 slicer where this setting is in the menu because I cannot find it. This would save me so much time.

Share this post

Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now

  • Create New...