layer shifting around geometries like holes etc

[shayan 0]

I have been experiencing micro layer shifts if i am not wrong in 3d print parts. they generally appear when there are features like circular, square holes in model and evens out after certain distance. i am not able to figure out whats the issue. all the belts, pulleys and screws are sufficiently tight enough. no slip any where. cura engine also dosent shown any shift in layers while simulating layer view. someone please hep me. i am fed up of these micro layer shifts.

[395V 0]

Too much acceleration and jerk values?

[shayan 0]

Nope acceleration is 500 and jerk is 5😭

[Torgeir 264]

Switch of heat bed and use blue tape. (Pls. readjust bed height)

 

Let's see the result then..

 

Thanks

 

 

[shayan 0]

Heated bed was off and magigoo glue was used....actually you can notice that after certain distance the layer evens out.

 

Thank you