Jump to content

Ultimaker 3 bed won’t raise up.


Adam_k

Recommended Posts

Posted · Ultimaker 3 bed won’t raise up.

When I try to print something and the printer tries to raise the bed it moves a tiny bit and starts making this horrible noise. I can’t move the bed manually. It moves a little and than seems to get stuck and makes a noise. How do I fix it?

  • Link to post
    Share on other sites

    • 1 year later...
    • 1 year later...
    Posted (edited) · Ultimaker 3 bed won’t raise up.

    Hi @servant74,

     

    this seems to be the Z-end stop switch.

    The first thing the printer will do is to synchronize the the bed position, this is done by lowering the bed until bed end stop is sensed, then the stepper motor stop and reverse to the actual start position.

    In your case, the motor step down, but only reach the hard stop and jump back a step, this will go over and over and makes a lot of noise!

     

    The end switch is probably pressed to far down (out of adjustment), so that the bed "stop screw" do not reach the actuator lip. Of course, a faulty switch or unconnected connector for this end switch is also a possible error.

     

    Good luck

     

    Torgeir

    Edited by Torgeir
    text error.
    • Like 1
    Link to post
    Share on other sites

    Create an account or sign in to comment

    You need to be a member in order to leave a comment

    Create an account

    Sign up for a new account in our community. It's easy!

    Register a new account

    Sign in

    Already have an account? Sign in here.

    Sign In Now
    • Our picks

      • Introducing the UltiMaker Factor 4
        We are happy to announce the next evolution in the UltiMaker 3D printer lineup: the UltiMaker Factor 4 industrial-grade 3D printer, designed to take manufacturing to new levels of efficiency and reliability. Factor 4 is an end-to-end 3D printing solution for light industrial applications
          • Thanks
          • Like
        • 3 replies
      • UltiMaker Cura 5.7 stable released
        Cura 5.7 is here and it brings a handy new workflow improvement when using Thingiverse and Cura together, as well as additional capabilities for Method series printers, and a powerful way of sharing print settings using new printer-agnostic project files! Read on to find out about all of these improvements and more. 
         
          • Like
        • 26 replies
    ×
    ×
    • Create New...