Tapered thread in Fusion360

[clinton 7]

I want to print a collar with a thread that follows through the chamfer as below. If I cut the thread and the add the chamfer I get the required end result.

This is fine but I would like to add the chamfer first (so that I can use the chamfer as a cutting tool for the nut) and then add the thread. However, when I do it in the order of chamfer then thread I get this

Note, the thread stops at the top of the chamfer which means the nut won't go on.

Is there a way to get to what I want by adding the thread after the chamfer?

 

Edited June 10, 2020 by clinton

[Torgeir 248]

Hi clinton,

 

Try to use a cone cut, instead of chamfer.

Have never tried your way..

 

Thanks

 

Torgeir

Edited June 10, 2020 by Torgeir

[clinton 7]

Thanks Torgeir. What's a cone cut? Does it mean I can cut the shape and then apply the thread?

 

[Torgeir 248]

Hi clinton,

 

This is a right triangle that's rotated 360 deg around the coiled rods "center axe" forming a cone.

It can cut material outside or inside.

(Find some tutorials about this issue in the help section.)

 

Thanks