layer height

[galiana 0]

Hello, it's my first message.

Different layer height possible for each extruder?

 

TNX

[Carla_Birch 116]

Hi,

I not 100% sure but i don't think it is possible to print with different layer heights between nozzle, because you risk the nozzle printing with the lower height hitting the printed path of the other nozzle due to the fact its higher than the path being printed.

 

If you wishing to speed up the printing with the other nozzle you can use different nozzle sizes so that the paths print quicker.

Edited July 10, 2020 by Carla_Birch

[Framar 38]

As far as I know, No, it's not possible.

[Smithy 1,144]

It is only possible for infill which can be printed twice as thick, but that's probably not what you are looking for.

[nallath 1,123]

Nope, not possible. It's also not very likely that we will build that any time soon.