build dimensions problem

[bisdak 0]

Hi,

I have an issue with cura build dimension. I have set my printer build X=235 Y=235 but my 200x200 image doesn't fit.

[GregValiant 1,287]

It should fit.  If you have a 10mm skirt 10mm away from the 200 image it wouldn't slice but the image itself should fit.  A screen shot of the Cura build plate with the image on it would help.

[tinkergnome 927]

16 hours ago, bisdak said:

I have set my printer build X=235 Y=235 but my 200x200 image doesn't fit.

 

The question is... how have you done this and for which printer definition? Can you elaborate a bit?

 

One possible reason: If there are "disallowed areas" defined (visualized in dark grey on the build platform) those have to be changed as well.

 

[bisdak 0]

I 

On 8/24/2020 at 5:08 AM, tinkergnome said:

 

The question is... how have you done this and for which printer definition? Can you elaborate a bit?

 

One possible reason: If there are "disallowed areas" defined (visualized in dark grey on the build platform) those have to be changed as well.

 

I believe that is correct but I have  no idea hot to correct this.

[bisdak 0]

[bisdak 0]

But when I load this to S3D it fits just fine

[tinkergnome 927]

9 hours ago, bisdak said:

I believe that is correct but I have  no idea hot to correct this.

 

Here is a similar question with solution, but keep in mind that the contributor of the printer definition may have defined these areas for a reason... 🤷‍♂️