UltiMaker uses functional, analytical and tracking cookies. Tracking cookies enhance your experience on our website and may also collect your personal data outside of Ultimaker websites. If you agree with the use of tracking cookies, click “I agree, continue browsing”. You can withdraw your consent at any time. If you do not consent with the use of tracking cookies, click “Refuse”. You can find more information about cookies on our Privacy and Cookie Policy page.
The full stable release of UltiMaker Cura 5.4 is here and it makes it easier than ever to remove brims and supports from your finished prints. UltiMaker S series users can also look forward to print profiles for our newest UltiMaker PET CF composite material!
Recommended Posts
Labern 774
Looks like there is a lip on the top of the part that sticks out and why it's creating support.
You can add support blocker to the top section of you part and will stop your unwanted support.
Sometimes I try to adjust the support angle from 45 deg to 60 to reduce support on angled parts.
Link to post
Share on other sites