Modify Ultimaker 2 + extended temperature

[Criscuen 0]

Hello, very good, I have a question, I would like to modify the temperature and flow in an Ultimaker 2+ extended to use another type of filament, it would be possible, I have tried it in CURA and it does not let me, thanks

[Smithy 1,144]

Check in Cura in the printer settings if you have Marlin as GCode flavor. This is important to set the temperature in Cura, otherwise you have to configure the material in the printer itself.

[Criscuen 0]

It does not have Marlin, so it would have to be done from the printer screen, could you tell me how to do it?  thanks

 

[Smithy 1,144]

You have Marlin as GCode flavour, believe me.... 😀 

 

[tinkergnome 927]

41 minutes ago, Criscuen said:

have to be done from the printer screen, could you tell me how to do it?

 

In case you want to stick with "UltiGCode":

 

https://support.ultimaker.com/hc/en-us/articles/360013127919

 

[Criscuen 0]

Thank you very much for everything, I tell you when I open the CURA I don't get the Marlin thing, it could be because I have not added the network printer, but rather, I added the printer.  Although it is true that I update the firmware of the printer from CURA.

[Smithy 1,144]

Hmm? network is not available for the UM2 so this is not the reason. Have you added the printer as an UM2+ Extended?

Can you post a screenshot of your machine settings page like mine above?

Which Cura version do you use?

[Criscuen 0]

ok, ahora te lo envío

[Smithy 1,144]

Looks good and now change it to Marlin instead of Ultimaker 2, just click on the drop down.

 

[Criscuen 0]

OK thank you very much