Is there a parameter for "extruder enabled" that can be read in the start/end G-code?

[zhutwo 0]

As the title says. Haven't been able to find any answers through Google.

[nallath 1,123]

No.

[GregValiant 1,287]

After carefully parsing through @nallath 's answer (and then taking a moment to look around) it appears that like many other things in Gcode, there is no way to do a query.

 

M590 is listed on the Reprap Wiki site but it doesn't appear to be supported by any firmware (except maybe Klipper).

[nallath 1,123]

Some firmware has the ability to interpret if statements in g-code, so i guess that is what zhutwo is looking for. But the cura parameters that you can put in the g-code are limited to settings only. 

[zhutwo 0]

Yes, it would be an if statement to check if an extruder is enabled before setting its temp. Enabling/disabling an extruder in Cura is kind of a setting, so I was hoping it would be a thing.