- If the print always fails at exactly the same height, check your Z Axis.
- This seems like a very thin and high part, does the wall start to wobble at some point maybe?
- How is general adhesion between layers? Try to increase line width by 10-20%, that way the filament gets "squished" and sticks better to itself.
Edited by Ray_McRay
Recommended Posts
Orange1234 1
Okay, so now most of my prints failed... 7 of 8 had exactly this issue, that it was perfect half way through and then failed. Any ideas? 😕
Link to post
Share on other sites