I mean I'm looking at the red and green arrows on your most recent photo and it looks to me like it goes inwards temporarily and then recovers. If you look at the part in real life is this true? This could be caused by underextrusion for a few layers.
Recommended Posts
Top Posters In This Topic
28
23
11
6
Popular Days
Dec 28
12
Dec 31
11
Jan 3
10
Jan 6
10
Top Posters In This Topic
Dim3nsioneer 28 posts
gr5 23 posts
illuminarti 11 posts
znib 6 posts
Popular Days
Dec 28 2013
12 posts
Dec 31 2013
11 posts
Jan 3 2014
10 posts
Jan 6 2014
10 posts
gr5 2,192
So I'm going back over all your prints again. They look much better starting when you tightened the belts but you seem to have this horizontal line where there is underextrustion and then it recovers. The "displacement" in X and Y seems to be fixed, right? now you get a skinnier couple of layers. I think you are just printing too fast. Lower your print speed to 50mm/sec. My above print was at 50mm/sec, 225C (both green and blue prints).
Link to post
Share on other sites