UltiMaker uses functional, analytical and tracking cookies. Tracking cookies enhance your experience on our website and may also collect your personal data outside of Ultimaker websites. If you agree with the use of tracking cookies, click “I agree, continue browsing”. You can withdraw your consent at any time. If you do not consent with the use of tracking cookies, click “Refuse”. You can find more information about cookies on our Privacy and Cookie Policy page.
Posted
· Model does not fit to Ultimaker 3 print area?
Do this at your own risk.
You can extend the printer build plate size in the settings you have posted. I also ran into the same problem as you and increased it just 5mm and that was enough. This worked on the UM 2+ I have never tried on my S5 so I can not say it works for all system.
Link to post
Share on other sites
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
The full stable release of UltiMaker Cura 5.4 is here and it makes it easier than ever to remove brims and supports from your finished prints. UltiMaker S series users can also look forward to print profiles for our newest UltiMaker PET CF composite material!
Recommended Posts
IRobertI 516
Take a look at this and see if it helps:
https://support.ultimaker.com/hc/en-us/articles/360013799339-How-to-print-the-maximum-build-volume-in-Ultimaker-Cura
Link to post
Share on other sites
zakeen 3
Do this at your own risk.
You can extend the printer build plate size in the settings you have posted. I also ran into the same problem as you and increased it just 5mm and that was enough. This worked on the UM 2+ I have never tried on my S5 so I can not say it works for all system.
Link to post
Share on other sites