I actually think i fixed this. The glass plate was about an eighth of an inch off from back to front. Leveling would complete with no errors and print would just end. I manually adjusted the build plate to be a bit more level and it is now printing. The bug is, the machine should be throwing a leveling error but it is not. It just pretends like it is ok and prints nothing at all and cura states print complete.
-
1
Recommended Posts
gr5 2,224
Did you look at your print in PREVIEW Mode? Sometimes when you slice a part with, for example, thin walls nothing actually gets printed. When you say "i've printed these items before" did you reslice? Or is this old gcode?
Link to post
Share on other sites