UltiMaker uses functional, analytical and tracking cookies. Tracking cookies enhance your experience on our website and may also collect your personal data outside of Ultimaker websites. If you agree with the use of tracking cookies, click “I agree, continue browsing”. You can withdraw your consent at any time. If you do not consent with the use of tracking cookies, click “Refuse”. You can find more information about cookies on our Privacy and Cookie Policy page.
Posted
· Help - gaps in top layer and around outer walls
One other issue to note. I performed my extruder calibration using Repetier host. I measure 120mm on filament and command feed of 100 through Repetier manual controls. Turns out perfect every time with 20mm of filament left over. Now if I do that same test, but use the controls of the printer itself it over extrudes by 5mm. ?? Am I missing something here? Double checked my eprom e steps setting and nothing has changed. I’ll post some pics later on this evening.
Link to post
Share on other sites
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
We are happy to announce the next evolution in the UltiMaker 3D printer lineup: the UltiMaker Factor 4 industrial-grade 3D printer, designed to take manufacturing to new levels of efficiency and reliability. Factor 4 is an end-to-end 3D printing solution for light industrial applications
Cura 5.7 is here and it brings a handy new workflow improvement when using Thingiverse and Cura together, as well as additional capabilities for Method series printers, and a powerful way of sharing print settings using new printer-agnostic project files! Read on to find out about all of these improvements and more.
Recommended Posts
frankis1776 0
One other issue to note. I performed my extruder calibration using Repetier host. I measure 120mm on filament and command feed of 100 through Repetier manual controls. Turns out perfect every time with 20mm of filament left over. Now if I do that same test, but use the controls of the printer itself it over extrudes by 5mm. ?? Am I missing something here? Double checked my eprom e steps setting and nothing has changed. I’ll post some pics later on this evening.
Link to post
Share on other sites