How do you print full 330mm width on UMS5 in Cura?

[xtrude64 0]

Hello,

Has anyone figured out how to print the full stated dimensions on the UMS5? 

 

I really need to print the full 330 mm or very close to that (329.5mm)

 

I have seen a lot of people interested, but have not found the solution. I turned off adhesion, what else is limiting Cura from full size?

[Smithy 1,146]

There are some more options which decreases the bed size. 

Check this page, which should help:

https://support.ultimaker.com/hc/en-us/articles/360013799339-How-to-print-the-maximum-build-volume-in-Ultimaker-Cura

 

[xtrude64 0]

Thank you so much Smithy!!! That worked!. I had the build plate stuff but the others I did not.

[Smithy 1,146]

You are welcome! 

I can remember that it was really interesting to see all the options affecting the build size. When you read the details it is clear, but scrolling through all theses options in Cura - no chance 🙂 

[RogueWave 15]

Print at the angle one corner to another for the largest size SOMETIMES IT WORKS!