Slicer puting gaps between layers .

[shanta 0]

Hi

I just downloaded and ran 4.9_20210511_Ultimaker_Cura-4.9.1.AppImage 

Previous version was Ultimaker_Cura-4.9.0.AppImage

 

Since running the new version both slicers will do the fallowing.

 

 

 

should look link this

 

Any suggestions as to what went wrong and how to fix it?

 

Thanks

Shanta

[gr5 2,234]

That looks fine.  You appear to have a VERY thick layer height.  Maybe 2mm?  Try a layer height of 0.2mm.

[shanta 0]

I switched to a different filament and the problem disappeared. Not sure but that may have been the problem.

I went back to the filament setting and it then worked likely due to resetting of the variables.

 

I had a feeling it was a new bee problem.

 

Thanks so much for the support.

 

Shanta