I also tried messing around with the infill part and the infill ratio of that block did not change at all.
Just now, Ender3_v2_T35LA said:I also tried messing around with the infill part and the infill ratio of that block did not change at all.
Like the infill ratio. Not the actual advanced settings.
GregValiant 1,342
Go to "File | Save Project" and (if it isn't proprietary) post the 3mf file here.
20 minutes ago, GregValiant said:Go to "File | Save Project" and (if it isn't proprietary) post the 3mf file here.
I don’t know how to do that. Is stl file fine? Or do you want the gcode?
Just now, Ender3_v2_T35LA said:I don’t know how to do that. Is stl file fine? Or do you want the gcode?
Oh wait I found out. Gimme a sec
27 minutes ago, GregValiant said:Go to "File | Save Project" and (if it isn't proprietary) post the 3mf file here.
Here it is.
GregValiant 1,342
I think you did an export. The only thing in the 3mf was the model and it sliced fine using my printer and settings. I need the project file (also will be a 3mf) because it will contain your printer, the STL, and your settings.
In Cura, load the STL and set up the slice. Then, under the File menu select "Save Project" and create a 3mf file. Post that file here.
Urm… I think I did that but I’ll just do it again.
13 hours ago, GregValiant said:I think you did an export. The only thing in the 3mf was the model and it sliced fine using my printer and settings. I need the project file (also will be a 3mf) because it will contain your printer, the STL, and your settings.
In Cura, load the STL and set up the slice. Then, under the File menu select "Save Project" and create a 3mf file. Post that file here.
Here it is. I hope i did it correctly now.
GregValiant 1,342
Turn off "Make overhangs printable". It's doing just what it says - instead of an overhang you get part structure.
-
2
Ok. I’ll go home to check. I will update you soon.
GregValiant 1,342
It's in the Experimental section of the settings. The tooltip should read "DO NOT USE".
-
1
Ohhhhh yess!!!!! How was is even ticked. I didnt even touch the experimental settings. Anyways, yes it works now and thank you very much Greg!
Recommended Posts
GregValiant 1,342
Look at the mesh fixes section. The only thing you might want selected is "union overlapping volumes". The rest should be de-selected. If "remove all holes" was selected it was the problem.
Link to post
Share on other sites
Ender3_v2_T35LA 0
I tried doing what you said but everything was already deselected except for Union overlapping volumes and remove empty first layers. I deselected “remove empty first layers” and it came out the same thing. What else should I check?
Link to post
Share on other sites