Vor 11 Minuten sagte Smithy:War es die Firmware oder hast du etwas anderes gefunden?
ja es war die Firmware natürlich war es aber auch die kaputte Platine
Vor 11 Minuten sagte Smithy:War es die Firmware oder hast du etwas anderes gefunden?
ja es war die Firmware natürlich war es aber auch die kaputte Platine
Danke und freut mich, dass wieder alles funktioniert!
Happy Printing 🙂
Hallo,
8 hours ago, CAD_product_design said:als ich die Platine ausgetauscht habe, habe ich jedes Kabel beschriftet deswegen glaube ich nicht das ich dort einen Fehler gemacht habe.
Also je nachdem welche Board Version dein altes kaputtes Board hatte muss du das neue Board etwas anders Anschließen sonst erfährst du nichts von Erneuerungen!
Lief dein Hotendfan vorher dauerhaft oder schaltet er sich an/aus je nachdem wie warm dein Hotend ist?
Gruß
Am 13.07.2021 um 17:57 Uhr sagte zerspaner_gerd:Hallo,
Also je nachdem welche Board Version dein altes kaputtes Board hatte muss du das neue Board etwas anders Anschließen sonst erfährst du nichts von Erneuerungen!
Lief dein Hotendfan vorher dauerhaft oder schaltet er sich an/aus je nachdem wie warm dein Hotend ist?
Gruß
Er schaltet sich an wenn man ihn braucht.
Recommended Posts
Smithy 1,146
War es die Firmware oder hast du etwas anderes gefunden?
Link to post
Share on other sites