How about an Ultimaker 3? I am having the same issue of the printer not recognizing the spool and there not being a PETG profile to set manually. Any suggestions? Thanks.
You can just wait with the UM3 until Ultimaker brings a new firmware to autodetect the spool.
As far as I know they are working on it and also on a PETG quality profile for the UM3.
In the meantime you can use the CPE profile and load it manually. (Generic CPE)
-
1
-
Our picks
-
Introducing the UltiMaker Factor 4
ArunC posted a topic in UltiMaker 3D printers,
We are happy to announce the next evolution in the UltiMaker 3D printer lineup: the UltiMaker Factor 4 industrial-grade 3D printer, designed to take manufacturing to new levels of efficiency and reliability. Factor 4 is an end-to-end 3D printing solution for light industrial applications-
-
- 3 replies
.thumb.jpeg.0b7a05eafc09add17b8338efde5852e9.jpeg)
Picked By
MariMakes, -
-
UltiMaker Cura 5.7 stable released
ArunC posted a topic in UltiMaker Cura,
Cura 5.7 is here and it brings a handy new workflow improvement when using Thingiverse and Cura together, as well as additional capabilities for Method series printers, and a powerful way of sharing print settings using new printer-agnostic project files! Read on to find out about all of these improvements and more.
-
-
- 26 replies
Picked By
MariMakes, -
-
.thumb.jpeg.0b7a05eafc09add17b8338efde5852e9.jpeg)
Recommended Posts
Smithy 1,144
Yes, firmware 6.4 or higher is needed for the UM PETG material.
Link to post
Share on other sites