Error Found in Shell Settings Description?

[tstone52 0]

 

The ultimaker website has the following description. Should it not say "leaves a gap of 0.025mm on both sides"? 

 

Outer wall inset

This setting compensates the position for the outer wall, if the line width chosen is smaller than the nozzle. For example: A line width of 0.35 with a 0.40mm nozzle leaves a gap of 0.05mm on both sides of the actual printed line. A compensation of 0.025 is set to compensate for the outermost part.

 

 

Link to that page

https://support.ultimaker.com/hc/en-us/articles/360012512340-Shell-settings

 

[SandervG 1,521]

Hi @tstone52, I think you might have found something! Thanks for that. I will share it with the creators of that page for review and when they agree we'll incorporate your suggestion. Thanks again! 

[GregValiant 1,346]

I think a flogging is in order.  .02 lashes will teach em.