Disable Automatic Leveling on S3

[conductive_printing 1]

I am printing with conductive filament, which interferes with the capacitive leveling sensor and often causes the automatic process to fail (Ultimaker S3).  When I run the manual leveling setup, it still performs the automatic leveling before the print.  I would like to request that the manual leveling option disable the automatic leveling before the print, similar to how it was on the Ultimaker 3.  

[gr5 2,189]

You can also disable active leveling yourself: https://community.ultimaker.com/topic/23706-disable-automatic-active-bed-levelling-for-ultimaker-s5/?do=findComment&comment=293936

 

Normally I don't recommend this as most pieces of glass are not flat and you need active leveling to map out the hills on the glass but you have a very special case.

 

[conductive_printing 1]

The thread you linked seems to have worked well.  Thanks gr5!