I would think that covering the filament with a heat proof cover would work well for this. I hadn't thought of this, but this is a very good idea. And, a related use - I am going to try to anneal a small PA6-CF part but turning the bed temperature to 80 degrees for six hours after covering the part with a heat proof cover.
Recommended Posts
Pitt_Rad 1
Resolved 🙂
Printer button (middle one) on the touch screen. Click on Glass and you can set the target temp.
Link to post
Share on other sites
gr5 2,224
Oh. Well it's good to go through all the menus on the S5 just to see what is where. There's some good features hidden all around.
I recommend unspooling several meters of filament and placing the spool on top of the unspooled filament. Unspool the amount you expect to need to use (cura can tell you how many meters your print will need in the bottom right corner - among other places).
Link to post
Share on other sites