Adaptive Layer Height?

[JonJennings 0]

Hi Ultimaker People,

 

Is there a way to print the edge layer detail at a finer layer height than internal structural material.
for example on a simple round shaft placed vertically on the bedplate, could I print the external surface edges at a0.05mm layer height and then the internal material at a thicker 0.1mm layer height or even 0.2mm height. Obviously internal thicker layer height would have to be a multiple of the finer edge layer height and the finer edge layers would need to print first both the functional material and dissociable support material.

[ahoeben 1,956]

See the infill layer thickness setting:

https://github.com/Ghostkeeper/SettingsGuide/blob/master/resources/articles/infill/infill_sparse_thickness.md