UltiMaker uses functional, analytical and tracking cookies. Tracking cookies enhance your experience on our website and may also collect your personal data outside of Ultimaker websites. If you agree with the use of tracking cookies, click “I agree, continue browsing”. You can withdraw your consent at any time. If you do not consent with the use of tracking cookies, click “Refuse”. You can find more information about cookies on our Privacy and Cookie Policy page.
Stripped Allen Key Screw Holes on the Back of Ultimaker 2+
Posted
· Stripped Allen Key Screw Holes on the Back of Ultimaker 2+
It's not obvious because they are sort of hidden, but those screws go into nuts. Look inside your printer. Every screw goes into a nut. Your nuts fell out. You need to locate the nuts and stick them back in the slots before putting the screws back in.
They are standard M3 (3mm metric) nuts. Standard thread (0.5mm thread pitch) (versus fine pitch). In the USA some hardware stores have metric nuts and some don't. But if you tilt your UM2 you might see the nuts sliding around in there.
You UM2+ probably came with a green and black hex driver - much easier to use than an L shaped allen key.
In the Cura 5.8 stable release, everyone can now tune their Z seams to look better than ever. Method series users get access to new material profiles, and the base Method model now has a printer profile, meaning the whole Method series is now supported in Cura!
We are happy to announce the next evolution in the UltiMaker 3D printer lineup: the UltiMaker Factor 4 industrial-grade 3D printer, designed to take manufacturing to new levels of efficiency and reliability. Factor 4 is an end-to-end 3D printing solution for light industrial applications
Recommended Posts
gr5 2,224
It's not obvious because they are sort of hidden, but those screws go into nuts. Look inside your printer. Every screw goes into a nut. Your nuts fell out. You need to locate the nuts and stick them back in the slots before putting the screws back in.
They are standard M3 (3mm metric) nuts. Standard thread (0.5mm thread pitch) (versus fine pitch). In the USA some hardware stores have metric nuts and some don't. But if you tilt your UM2 you might see the nuts sliding around in there.
You UM2+ probably came with a green and black hex driver - much easier to use than an L shaped allen key.
Link to post
Share on other sites
ultimakereducator 1
Thanks so much! I found all of the nuts and put them back. I'm currently running a test print and it appears to be working.
Link to post
Share on other sites