GregValiant 1,342
Hello @ahoeben - I believe it's #11047. The poster is trying to fool Spiralize and use his support structure as part of his model. The travel lines seem to be generated as the support is built up.
I've not been able to figure out a way to fool it myself. I usually slice a base in normal mode and then slice the upper model in spiralize and marry the two files together at a convenient layer.
Recommended Posts
ahoeben 1,981
Export just includes the model. The idea of a "project" is that it includes the whole state of your Cura session: the model(s), all settings, and even your Cura preferences.
A link would be nice, so I don't have to go searching for it.
Link to post
Share on other sites