Thank you Illuminarti!
I've read a post by Ian who said that he uses 50 degrees for the buildplate instead of 75. So I followed his example.
The temperatue was 210 by the way.
I will start right away and change the settings. I'll let you know the result. :-)
Recommended Posts
illuminarti 18
50º is probably a bit low. I generally use a thin layer of glue, and 60º for the plate.
I'd start out printing slightly thicker layers. To be honest, after the test prints I've done lately, I'm not sure there's ever much of a need to go below 0.1mm layers - and certainly not while you're just figuring things out. Go for thicker layers, so things print quicker, and you can get through more iterations of your tests, faster.
Also, for a mostly convex shape like this, you shouldn't need any infill at all - just 0.8mm shell, and a bottom/top thickness that's at least 8 times your layer height should be fine.
You don't mention what print temperature you are using - if it's less than 230, I'd be inclined to try raising it to at least 230.
Link to post
Share on other sites