BASF PAHT CF15 Not Compatible with Material Station

[arj3090 2]

Does anyone know why the BASF PAHT is considered not compatible with material station?

 

I did a test by telling the printer it was a different material to get around the error, then adjusted print parameters accordingly and did a test print. Everything worked fine. So I am curious what was the decision that determined the material not compatible.

[Gero 54]

this material was marked as compatible for a while and could be used directly in the material station. 
however, either with the manufacturer itself or with a certain number of users, there were frequent problems with the material breaking in the station because it is extremely stiff. for this reason, the material was again marked as unsuitable. 
i seem to remember an explanation in some thread. 

nevertheless, it should be possible to use the material with the generic profile.