Octoprint not taking Cura GCode.

[Semtex_Dyna_Rider 0]

Hey guys, 

 

Me again, so I finally got Octoprint and Cura to work together and got half of Thor's Hammer built. Left it a day and tried to build the second half but run into the below error. 

 

Its giving me an error that my gcode has not supplied retraction lenght, Retractions speed etc, I tried on basic and advianced and no joy. Please see supplied pics. It was working fine and now not. 

 

Should I delete Octoprint and start again? Any advise would be awesome. 

 

 

[Nhemmer 0]

Any resolve to this?  I have the same issue.  🤔

 

 

Thanks!

[ahoeben 1,968]

See this article: https://github.com/FormerLurker/Octolapse/wiki/V0.4---Automatic-Slicer-Configuration