Jump to content

Cura not connected to printer (wifi) (tired of walking by USB stick to printer)

Tim_Cochrane

By Tim_Cochrane
in UltiMaker Cura

 Share

Recommended Posts

Tim_Cochrane

Tim_Cochrane 3

Posted
Posted · Cura not connected to printer (wifi) (tired of walking by USB stick to printer)

I have an UM5 (latest firmware) connected to Cura (4.13.1) via wifi. It worked fine for the past 4 weeks after I moved my office, but it has now stopped.

 

1. I have rebooted the router, computer, and printer.

2. I tried to connect the printer within Cura.

 

I'm not sure what to do or what to try. Can anybody give me some advice on how to get the purple smoke to work again?


Thanks,

Tim

    • Link to post
    Share on other sites
    Smithy

    Smithy 1,144

    Posted
    Posted · Cura not connected to printer (wifi) (tired of walking by USB stick to printer)

    Sometimes it helps a lot when you give your printer a fixed IP address. Then you have also the possibility to configure the printer manually in Cura with that IP and avoid the auto detection which could fail sometimes.

    • Link to post
    Share on other sites

    Create an account or sign in to comment

    You need to be a member in order to leave a comment

    Create an account

    Sign up for a new account in our community. It's easy!

    Register a new account

    Sign in

    Already have an account? Sign in here.

    Sign In Now
     Share
    Followers 0
    Go to topic listing

    • Our picks

      • UltiMaker Cura 5.7 stable released

        UltiMaker Cura 5.7 stable released

        ArunC posted a topic in UltiMaker Cura,

        Cura 5.7 is here and it brings a handy new workflow improvement when using Thingiverse and Cura together, as well as additional capabilities for Method series printers, and a powerful way of sharing print settings using new printer-agnostic project files! Read on to find out about all of these improvements and more. 
         
          • Like
        • 18 replies
        MariMakes

        Picked By

        MariMakes,

      • Release Notes: S-Line Firmware 8.3.0 (Latest)

        Dustin posted a topic in Firmware,

        S-Line Firmware 8.3.0 was released Nov. 20th on the "Latest" firmware branch.
        (Sorry, was out of office when this released)

        This update is for...
        All UltiMaker S series  
        New features
         
        Temperature status. During print preparation, the temperatures of the print cores and build plate will be shown on the display. This gives a better indication of the progress and remaining wait time. Save log files in paused state. It is now possible to save the printer's log files to USB if the currently active print job is paused. Previously, the Dump logs to USB option was only enabled if the printer was in idle state. Confirm print removal via Digital Factory. If the printer is connected to the Digital Factory, it is now possible to confirm the removal of a previous print job via the Digital Factory interface. This is useful in situations where the build plate is clear, but the operator forgot to select Confirm removal on the printer’s display. Visit this page for more information about this feature.
          • Like
        • 0 replies
        MariMakes

        Picked By

        MariMakes,
      View All
    ×
    ×
    • Create New...