Thanks GregValiant for the reply.
I'm still digesting the overall 3d printer ecosystem; no, I haven't reached them as they don't seem super reacheable on this specific printer, which works fine.
They provide you with a link to a Ultimaker Care "special" version I'd say, which has M22Z configuration. Once you upgrade to the offered one, you lose everything (so the advice is to not upgrade).
On the amazon page there is a buyer commenting that he's using another software to produce gcode for the M22Z... would it be possible?
Thanks again,
Alessio
Recommended Posts
GregValiant 1,342
Did you ask Cubicon if they submitted an M22Z definition to Ultimaker? Some of their printers are included in Cura. If the M22Z is a new model then maybe you have to wait for a future release of Cura for the definition files to be included.
Another thing is that my installation of 4.10 doesn't have a definition for the M22Z. Is your version of 4.10 an Ultimaker version or a fork from Cubicon?
Edited by GregValiantLink to post
Share on other sites