Ultimaker uses functional, analytical and tracking cookies. Tracking cookies enhance your experience on our website and may also collect your personal data outside of Ultimaker websites. If you agree with the use of tracking cookies, click “I agree, continue browsing”. You can withdraw your consent at any time. If you do not consent with the use of tracking cookies, click “Refuse”. You can find more information about cookies on our Privacy and Cookie Policy page.
Het idee bij de Ultimaker 2 was om één G-code bestand te maken wat dan door op de printer het materiaal in te stellen met diverse materialen kon worden geprint. Dat betekent dat de printer (en niet Cura) de controle heeft over deze instellingen.
Als je toch volledige controle wilt hebben over de materialen in Cura (en dus de instellingen op de printer wilt negeren), dan kan je in de "Machine Settings" de G-code flavor op "Marlin" zetten ipv "Ultimaker 2". Je printer zal dan wel 'klagen' dat de g-code de instellingen op de printer negeert als je de print start.
I'm excited because I've personally produced this showcase event, so if you are curious what else I'm up to nowadays, come check it out and say hi in the chat! It would mean a lot!
Often getting started is the most difficult part of any process. A good start sets you up for success and saves you time and energy that could be spent elsewhere. That is why we have a onboarding course ready for
Ultimaker S5 Pro Bundle, Ultimaker S5, Ultimaker S3 Ultimaker 2+ Connect.
They're ready for you on the Ultimaker Academy platform. All you need to do to gain access is to register your product to gain free access.
Ready? Register your product here in just 60 seconds.
Recommended Posts
ahoeben 1,587
Het idee bij de Ultimaker 2 was om één G-code bestand te maken wat dan door op de printer het materiaal in te stellen met diverse materialen kon worden geprint. Dat betekent dat de printer (en niet Cura) de controle heeft over deze instellingen.
Als je toch volledige controle wilt hebben over de materialen in Cura (en dus de instellingen op de printer wilt negeren), dan kan je in de "Machine Settings" de G-code flavor op "Marlin" zetten ipv "Ultimaker 2". Je printer zal dan wel 'klagen' dat de g-code de instellingen op de printer negeert als je de print start.
Link to post
Share on other sites