GregValiant 1,342
MS 3D Builder was able to repair it also.
Since it's for a good cause here is your graduation present. The support blocker is configured as a cutting mesh to keep all the little things that don't print well from printing at all. I think it would look pretty good in Silky Gold filament.
Edited by GregValiant
Recommended Posts
GregValiant 1,342
Well this would do it...
-> Analyzed your file:
--> 2041 Naked edges (?)
--> 35 Planar holes (?)
--> 91 Non-planar holes (?)
--> 1 Non-manifold edges (?)
--> 51 Inverted faces (?)
--> 0 Degenerate faces (?)
--> 2 Duplicate faces (?)
--> 0 Disjoint shells (?)
-> Vertex count changed from 39462 to 48011 (+8549)
-> Triangle count changed from 76715 to 97056 (+20341)
The web service was able to repair it. Whether it's right or not I don't know. Your model is on the right. The pink areas indicate errors.
You won't print this with a .4 nozzle at 100% scale. You would need to go to 200% to have a chance and the line width would need to be .35. A .2 nozzle would be a better choice at full scale. Some of the supports would be difficult to remove without trashing the print.
Link to post
Share on other sites
Root720 0
Okay thankyou so much! Interior didn't matter as much, as I was just using it for the shape! I wasnt sure how to go about repairing or anything like this so this helps a lot!!!
Link to post
Share on other sites