Tried your project file on cura 4.13 windows version and it sliced perfectly so not sure whats happening on your end.
-
1
Tried your project file on cura 4.13 windows version and it sliced perfectly so not sure whats happening on your end.
On 5/26/2022 at 4:22 PM, obewan said:Tried your project file on cura 4.13 windows version and it sliced perfectly so not sure whats happening on your end.
Good to know. Thx
I tried Cura 5.0.0 and I have the issue at super quality only.
It's gonna be a mystery.
On a lark I opened the model in MS 3D Builder and it reported an error.
This report is from https://formware.co/OnlineStlRepair. There were some triangles added but that's it.
--> 0 Naked edges (?)
--> 0 Planar holes (?)
--> 0 Non-planar holes (?)
--> 0 Non-manifold edges (?)
--> 0 Inverted faces (?)
--> 0 Degenerate faces (?)
--> 0 Duplicate faces (?)
--> 0 Disjoint shells (?)
-> Repairing: 100.00%
----- Repair completed in 279ms ------
-> Vertex count changed from 112 to 300 (+188)
-> Triangle count changed from 220 to 596 (+376)
3D builder before repair
And after repair. You can see where the triangles were added to the flats between the ribs.
Ok thanks for pointing https://formware.co/OnlineStlRepair.
I tried the .3mf file with Cura 5 on Windows and I got no issues !!
So I'll try fixed STL on Linux again and see.
To be continued ...
19 hours ago, GregValiant said:On a lark I opened the model in MS 3D Builder and it reported an error.
This report is from https://formware.co/OnlineStlRepair. There were some triangles added but that's it.
--> 0 Naked edges (?)
--> 0 Planar holes (?)
--> 0 Non-planar holes (?)
--> 0 Non-manifold edges (?)
--> 0 Inverted faces (?)
--> 0 Degenerate faces (?)
--> 0 Duplicate faces (?)
--> 0 Disjoint shells (?)
-> Repairing: 100.00%
----- Repair completed in 279ms ------
-> Vertex count changed from 112 to 300 (+188)
-> Triangle count changed from 220 to 596 (+376)
3D builder before repair
And after repair. You can see where the triangles were added to the flats between the ribs.
I guess OnlineStlRepair is make a safer 3D model.
Fixed STL fixed the issue.
Thank you every one. 👍
(original STL exported from Freecad)
Edited by nelstaar
Recommended Posts
nelstaar 0
Attached file.
porte savon évier - bug.3mf
Link to post
Share on other sites