getConvexHull In case of one-at-a-time

[Cuq 173]

Hello Again the Cura Expert,

 

In my current code I'm using :

hull_polygon = node.callDecoration("getConvexHull")

hull_polygon = node.callDecoration("getConvexHull")

and 

hull_polygon = node.callDecoration("getAdhesionArea")

 

Works great. But I have an issue with  getConvexHull  according to the source code in case of one-at-a-time, this includes adhesion and head+fans clearance.  Is there any method to keep the "minimal" ConvexHull  and not the getConvexHullHeadFull.

 

Best regards,

 

Cuq

Edited June 3, 2022 by Cuq

[Cuq 173]

I hate this kind of situation... finally writing the question gives me the answer...

Well I didn't lose everything and maybe one day someone will have the same question

 

The answer are : _compute2DConvexHull

[nallath 1,117]

Ah! You have discovered the magic of rubber duck debugging: https://en.wikipedia.org/wiki/Rubber_duck_debugging

[Cuq 173]

no, no ...  Just the file Ultimaker Cura 5.0.0\cura\Scene\ConvexHullDecorator.py and its comments 🤗