UltiMaker uses functional, analytical and tracking cookies. Tracking cookies enhance your experience on our website and may also collect your personal data outside of Ultimaker websites. If you agree with the use of tracking cookies, click “I agree, continue browsing”. You can withdraw your consent at any time. If you do not consent with the use of tracking cookies, click “Refuse”. You can find more information about cookies on our Privacy and Cookie Policy page.
We just went through this with an Ender 3 Pro that had the problem. A workaround seems to have gotten the job done. It is described in THIS THREAD .
NOTE: When using the M25 command it's possible that you might have to "Pause" the print on the LCD (even though the printer is in pause mode) in order to bring up the "Resume" command.
So that sequence would be...
The file is printing and comes to the pause section. It parks the head and the M25 causes the printer to pause.
You put the magnet in.
On the LCD find the menu with the "pause" command and click on "Pause" and then move to the Resume command and click on it.
The G4 method always works but you lose control of the printer because G4 is a timed event. You don't get to choose when the printer restarts.
Edited by GregValiant
Link to post
Share on other sites
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
We are happy to announce the next evolution in the UltiMaker 3D printer lineup: the UltiMaker Factor 4 industrial-grade 3D printer, designed to take manufacturing to new levels of efficiency and reliability. Factor 4 is an end-to-end 3D printing solution for light industrial applications
Cura 5.7 is here and it brings a handy new workflow improvement when using Thingiverse and Cura together, as well as additional capabilities for Method series printers, and a powerful way of sharing print settings using new printer-agnostic project files! Read on to find out about all of these improvements and more.
Recommended Posts
GregValiant 1,287
We just went through this with an Ender 3 Pro that had the problem. A workaround seems to have gotten the job done. It is described in THIS THREAD .
NOTE: When using the M25 command it's possible that you might have to "Pause" the print on the LCD (even though the printer is in pause mode) in order to bring up the "Resume" command.
So that sequence would be...
The file is printing and comes to the pause section. It parks the head and the M25 causes the printer to pause.
You put the magnet in.
On the LCD find the menu with the "pause" command and click on "Pause" and then move to the Resume command and click on it.
The G4 method always works but you lose control of the printer because G4 is a timed event. You don't get to choose when the printer restarts.
Link to post
Share on other sites