Ultimaker uses functional, analytical and tracking cookies. Tracking cookies enhance your experience on our website and may also collect your personal data outside of Ultimaker websites. If you agree with the use of tracking cookies, click “I agree, continue browsing”. You can withdraw your consent at any time. If you do not consent with the use of tracking cookies, click “Refuse”. You can find more information about cookies on our Privacy and Cookie Policy page.
Not able to See Cross sectional views w.r.t any planes including the height of the Cutting plane w.r.t to any plane
Posted
· Not able to See Cross sectional views w.r.t any planes including the height of the Cutting plane w.r.t to any plane
Cura has cross sectional views but *only* horizontal ones. So you can use the vertical slider on the right side of PREVIEW and (for example - if you are inserting a nut) slide it up until you find the area for the nut and then where the model starts covering the nut.
Also the vertical slider has a second control at the bottom so you can remove the bottom of the part as well and look at your part in cross section from below.
However, I agree a vertical cross section view would be really really nice!
1
Link to post
Share on other sites
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Often getting started is the most difficult part of any process. A good start sets you up for success and saves you time and energy that could be spent elsewhere. That is why we have a onboarding course ready for
Ultimaker S5 Pro Bundle, Ultimaker S5, Ultimaker S3 Ultimaker 2+ Connect.
They're ready for you on the Ultimaker Academy platform. All you need to do to gain access is to register your product to gain free access.
Ready? Register your product here in just 60 seconds.
Recommended Posts
gr5 1,872
Cura has cross sectional views but *only* horizontal ones. So you can use the vertical slider on the right side of PREVIEW and (for example - if you are inserting a nut) slide it up until you find the area for the nut and then where the model starts covering the nut.
Also the vertical slider has a second control at the bottom so you can remove the bottom of the part as well and look at your part in cross section from below.
However, I agree a vertical cross section view would be really really nice!
Link to post
Share on other sites