Jump to content

Cannot sync materials between Cura and S3 printer


LoS

Recommended Posts

Posted · Cannot sync materials between Cura and S3 printer

Hi,

 

For some time, I cannot sync materials between Cura and my S3 printer. I don't know the cause, everytime I tried to sync them using Cura, it fails somehow.

In Cura 5.x the dialog windows gets stuck and it stays that way forever

In Cura 4.x it (sometimes) it announces success, but the new materials don't get to the printer.

 

This happened since I've upgraded to 7.0.3 firmware or when I resetted the digital factory connection for the third time. I'm not sure when it happened, both these actions were done at about the same time.

 

Is there anyone experiencing the same problems with material sync?

 

image.thumb.png.438521f9b2522f3a563d8af3253fb103.png

  • Like 1
Link to post
Share on other sites

Posted · Cannot sync materials between Cura and S3 printer

It works for me, but that's not really something that helps you in any way.

Could you share the cura logs? There might be some info there.

  • Link to post
    Share on other sites

    Posted (edited) · Cannot sync materials between Cura and S3 printer

    Thanks for your answer.

     

    I've attached the log (5.1.0 log). Last attempt was at about 12:00 today

    cura.log

    Edited by LoS
  • Link to post
    Share on other sites

    Create an account or sign in to comment

    You need to be a member in order to leave a comment

    Create an account

    Sign up for a new account in our community. It's easy!

    Register a new account

    Sign in

    Already have an account? Sign in here.

    Sign In Now
    • Our picks

      • UltiMaker Cura 5.4 stable released
        The full stable release of UltiMaker Cura 5.4 is here and it makes it easier than ever to remove brims and supports from your finished prints. UltiMaker S series users can also look forward to print profiles for our newest UltiMaker PET CF composite material!
          • Like
        • 58 replies
    ×
    ×
    • Create New...