UltiMaker uses functional, analytical and tracking cookies. Tracking cookies enhance your experience on our website and may also collect your personal data outside of Ultimaker websites. If you agree with the use of tracking cookies, click “I agree, continue browsing”. You can withdraw your consent at any time. If you do not consent with the use of tracking cookies, click “Refuse”. You can find more information about cookies on our Privacy and Cookie Policy page.
Posted
· Cura Stützstruktur zwischen Modell und Druckbett
Wenn Du nur einen durchgängigen "Abstandshalter" suchst, wär das Raft was für Dich.
Aber, die Unterseite wird nicht wirklich so schön und glatt werden, wie wenn Du direkt auf dem Druckbett druckst.
Klar sieht die Unterseite anders aus, als die Seitenwand. Die ist ja bei einer Glasplatte schön glatt, und damit wird der Übergang zwischen den einzelnen Bahnen geglättet. An den Seitenwänden sind die Bahnen deutlicher zu sehen, je nach gewählten Einstellungen.
Auf einem Raft gedruckt, wird die Unterseite recht rauh werden.
Cura 5.7 is here and it brings a handy new workflow improvement when using Thingiverse and Cura together, as well as additional capabilities for Method series printers, and a powerful way of sharing print settings using new printer-agnostic project files! Read on to find out about all of these improvements and more.
S-Line Firmware 8.3.0 was released Nov. 20th on the "Latest" firmware branch.
(Sorry, was out of office when this released)
This update is for...
All UltiMaker S series
New features
Temperature status. During print preparation, the temperatures of the print cores and build plate will be shown on the display. This gives a better indication of the progress and remaining wait time. Save log files in paused state. It is now possible to save the printer's log files to USB if the currently active print job is paused. Previously, the Dump logs to USB option was only enabled if the printer was in idle state. Confirm print removal via Digital Factory. If the printer is connected to the Digital Factory, it is now possible to confirm the removal of a previous print job via the Digital Factory interface. This is useful in situations where the build plate is clear, but the operator forgot to select Confirm removal on the printer’s display. Visit this page for more information about this feature.
Recommended Posts
TTX380 13
Wenn Du nur einen durchgängigen "Abstandshalter" suchst, wär das Raft was für Dich.
Aber, die Unterseite wird nicht wirklich so schön und glatt werden, wie wenn Du direkt auf dem Druckbett druckst.
Klar sieht die Unterseite anders aus, als die Seitenwand. Die ist ja bei einer Glasplatte schön glatt, und damit wird der Übergang zwischen den einzelnen Bahnen geglättet. An den Seitenwänden sind die Bahnen deutlicher zu sehen, je nach gewählten Einstellungen.
Auf einem Raft gedruckt, wird die Unterseite recht rauh werden.
Link to post
Share on other sites