Nozzle printing "in mid-air" when sliced.

[finity69x2 0]

I'm not really sure how to explain what I'm seeing.

 

I use Cura 5.0.

 

When I slice some models the generated g-code tells the nozzle to print in mid-air outside of the bounds of the model itself. This causes a TON of stringing.

 

But I don't know what setting to change to fix it or even why it's doing it.

 

This never happened in Cura 4.x

[GregValiant 1,319]

A couple of example files would help.

Load a model with your settings profile that causes this and then use "File | Save Project" and post the 3mf file here.  It might be helpful if you would also post one of the "bad" gcode files.

Settings like "Lift Head" and "Wipe Nozzle between Layers" can have this effect.

[finity69x2 0]

here you go.

case mount.3mf case mount.gcode

[GregValiant 1,319]

This one is with "Wipe Nozzle Between Layers" enabled in your 3mf file (it's in the Experimental section).

 

And this one is with it disabled.

 

 

I suggest you always start out a Cura session by using the  Setting Visibility tool (to the right of the Setting Search bar) and set the visiblity to "All".  Sometimes you need one of these settings ("Remove all Holes" and "Make Overhangs Printable" are favorites) and then forget about it and they remain enabled and your next project is wonky.  If a setting is out of sight it's out of mind.

Edited September 22, 2022 by GregValiant

[finity69x2 0]

I actually had the wipe nozzle between layers enabled.

 

I disabled it and re-sliced and I think it's working now.

 

I'm reprinting now so we'll see how it goes but I think it should be good now.

 

TBH, I'm not even sure why I had it enabled in the first place.

 

Thanks for the help.

Edited September 22, 2022 by finity69x2

[MariMakes 199]