Adjust temp by non ultimaker filament

[ceeshermans 0]

If I use filament from other manufacure then Ultimaker how can i adjust the core temperture for this particular filament?

[ahoeben 1,956]

You can not "edit" the materials that come with Cura. They are "read-only". You can "duplicate" those read-only materials, and edit the duplicates. This is the same for Ultimaker materials by the way.

[ceeshermans 0]

4 hours ago, ahoeben said:

You can not "edit" the materials that come with Cura. They are "read-only". You can "duplicate" those read-only materials, and edit the duplicates. This is the same for Ultimaker materials by the way.

Thanks for the response but that you wrote I know. If I use an filament other then Ultimaker which requires 240 degree core temperature, how do I adjust this temperature. Yes its possible to do this when the printer is idle but at the moment it receives the order to print the temperatuur goes back to the standard temperature.

[MariMakes 199]

Hey  @ceeshermans,

 

Welcome to the Ultimaker Community 🚀

If it's just a few printjobs you want to change the temperature, you can change it in the settings here:

If you intent to use the material more you can create a new material with the new temperature as default. Like @ahoeben suggested, tou can do this by duplicating the existing materials.



When you do this, please make sure that you don't change the Material Type. When you changed it too much you'll see this: 

 

Good luck! Will you let us know if this worked for you? 👼

[ceeshermans 0]

Thanks, it works>